Weight: 2096 g
REACH: contains SVHC materials >0.1% w/w
Case-hardened steel, nitrided, manganese phosphated and ground
Case-hardened steel, nitrided, manganese phosphated
The thread bore must always be closed for safe functioning, e.g. set screw M 12 x 10.
For specific clamping situations, the standard clamping jaws supplied can be exchanged or replaced (see catalogue drawing: screw ISO 4762 - M8 - 12.9, M max. = 43 Nm).
Additional flexible possibility of fitting with holder 23470.0250 or holding plate for down-hold clamps 23210.0740.
Mount the floating clamp (M 12 connection thread) onto the device with a wrench (WS 46).
Adjust the height limit stop and the rotating area with the blue sleeve and clamp with a set screw (3 x WS 2.5). When setting the height limit, consider tolerance of workpiece.
Push the floating clamp downwards.
Pivot the clamping jaws inwards.
Release floating clamp. The bottom jaw contacts the workpiece with the force of the contact spring.
Tighten the fixture nut (WS 18) (max. torque 15 Nm).
The jaws clamp the workpiece - the clamp is still floating.
Then tighten the hexagon collar nut (WS 10) (max. torque 10 Nm).
The workpiece clamping process is complete.
Releasing is performed in the reverse order: Release hexagon collar nut (WS 10) - release hexagon nut (WS 18) - pivot out the clamping jaws
Floating clamp is in end position.
The most exciting variety in the realm of workpiece clamping
As an accessory, we offer clamping jaws with an increased clamping range, refer to 23320.0050-.0058, as well as pivot jaws, refer to 23320.0148-.0156.